Skyrail Technical chart
SKYRAIL is cost-competitive as it can be reused for at least 100 casts. The concrete doesn’t stick to the plastic so that the formwork can be cleaned with just some water, without using detergents or lubricants.
INSTALLATION AND DISMANTLING
The various elements can be connected with a high resistant nylon handle. The coupling is fast thanks to the just 90°degrees turn the elements can be perfectly fixed. A direction of place doesn’t exist both for SKYRAIL and the handle.
SKYRAIL is a modular element. It doesn’t need cuts od adaptations beacause only the neccessary elements for the cast are used.
SKYRAIL can be completely dismantled and it is not necessary to place it in dried places.
Thanks to its small size it can easily handled on-site and dismantled where needed.
SKYRAIL surface can be left in sight without any further rework.
Technical characteristics and packagings
SKYRAIL is moulded in ABS resistant to UV rays and chemical agents.
|ITEM||AXLE SPACING (cm)||SPAN (cm)||SKYRAIL HEIGHT (cm)||BASE HEIGHT (cm)||TOTAL HEIGHT (cm)||RIBBING (cm)||CONCRETE CONSUMPTION UP TO THE TOP (m3/m2)||CONCRETE CONSUMPTION (m3/m2)||PROPS SPACING (m)|
|ITEM||PALLET SIZE (cm)||PALLET NR. ITEMS / KG|
|SKYRAIL_H16||120 X 112 X 230||208||540|
|SKYRAIL_H20||120 X 112 X 232||204||570|
|SKYRAIL_H24||120 X 112 X 235||200||620|
|SKYBLOCK_H16||80 X 120 X 230||288||337|
|SKYBLOCK_H20||80 X 120 X 233||284||389|
|SKYBLOCK_H24||80 X 120 X 235||280||440|
|T JOIST||80 X 120 X 220||140||258|
SKYRAIL system installation
Place the iron props and the timber beams. Fix the supporting element to the wall.
Place the timber compensation panel or a GEOPANEL 80mm thick.
Place the 2 first rows of joists.
Place the timber compensation panel 25 mm thick.
Place the spacers between the joists.
Place the SKY BLOCK element.
Install the first SKYRAIL element.
Install SKYRAIL elements fixing them to each other.
ORDER OF INSTALLATION
In order to correctly place the compensation panels, it is necessary to consult GEOPLAST project tables before installing the slab elements.
SKYRAIL system dismantling
Remove the spacers.
Remove the props and the timber beams.
Remove the joists.
Remove SKYRAIL elements.
In correspondence of the ribs, shore up the floor as shown in GEOPLAST project tables until the complete curing of the concrete.
Comparison between similar products
|CHARACTERISTICS||SKYRAIL SYSTEM||HOLLOW CLAY-CONCRETE|
|SAFETY||The system is fully self-supporting||It requires a bottom reinforcement and safety features|
|SAVINGS||The system is completely amortised after just a few pours||Waste materials are used|
|UTILIZATION||REUSABLE||JUST ONE USE(waste materials)|
|CONCRETE ADHESION||The lack of brick lightens the structure, improving the anti- seismic characteristics||The brick self-weight amplifies a seismic effect due to higher oscillating mass of the structure|
|INSTALLATION||Its low weight permits a fast and easy place||The weight and the fragility of the materials make the installation very slow|
|STORAGE||It can be stored in limited spaces and it does not suffer moisture||Needs a large storage area|
|INSTALLATIONS||The hydraulic systems can be easily installed||no previous arrangements needed|